Empi 3412 Dual Port Intake Boot Kit For VW Bug – Black Rubber, Clamps, Gaskets Included

1 / 4

Description

This is the Empi 3412 dual port intake boot kit for the classic VW Beetle – you know, the air-cooled ones with the dual port intake manifolds.

3412 - EMPI VW Intake Manifold Installation Kit - Dual Port - with Black Boots

The kit comes with two black rubber intake boots, the clamps to secure them, and the gaskets you need to seal everything up properly.

3244 - EMPI Type 2/4 Intake Manifold Runners with Gaskets

These boots connect the intake manifold to the cylinder heads, and over time, the rubber gets hard, cracks, and causes vacuum leaks – which makes your VW run rough, idle poorly, or even stall.

EMPI 3236 VW BUG DUAL PORT INTAKE MANIFOLD END KIT

This kit from Empi is a direct replacement – all the parts are sized correctly for the dual port setup.

Dual Port Intake Instillation Kit, Urethane, Black Boots, Compatible

Empi is a well-known brand in the VW aftermarket, so you're getting decent quality parts.

Dual Port Boot Kit, Black with gaskets 00-3142-0

The boots are made of durable rubber that's flexible and resistant to oil and heat.
Installation is pretty straightforward – remove the old boots, clean the mating surfaces, put the new gaskets on, slide the new boots in place, and tighten the clamps.
It's a common maintenance item on older Bugs.
The manufacturer part number is 00-3412-0, and the UPC is 707924321760.
This is a brand new kit, never used.
If your Bug has been backfiring, losing power, or just not running right, this is one of the first things to check.
Replacing these boots is cheap and easy, and it can make a huge difference in how your engine runs.

Empi 3412 Vw Bug Dual Port Intake Boot Kit, Black Rubber Boots, Clamps, Gaskets | Australia

Perfect for a weekend DIY project.
Keep your air-cooled VW breathing properly.

9974 - EMPI Standard VW Swing Axle Boot Kit - Black - with Hardware